Xpient
Back Office PC |
Dell
Optiplex XE Form Factor PC
Linux OS with Unix TACO software
Additional Software:
OpenOffice
Do not power off the PC during operating
hours unless instructed to do so by
support.
Generally there are 5
cables/connections:
-
Power - thick, usually black
-
Network - similar to a large phone
cable
-
Keyboard (USB)
-
Mouse (USB)
-
Printer (USB)
-
Video - blue approx. 1" connector
- DT
Timer - usually thick gray cable
with approx. 1" connector
|
Click Here for Optiplex XE
Back Panel connections |
Uninterruptable Power Supply (UPS)
(Battery Backup) |
Tripp Lite
475w 800vA (models may vary)
The UPS
includes a battery which supplies power
to connected equipment in the event of a
power failure. Runtime depends on the
size of the battery/UPS and connected
equipment. Generally, it will supply
power for about 15 minutes.
If you think the power will be off for
more than 15 minutes, power down the PC
to avoid file corruption.
Note half of the outlets are battery
connected and half are not. The UPS is
useless if the PC is not connected to
the battery outlets.
Never connect a printer or other
high-powered device to the battery side
as it will drain the battery very
quickly during a power failure. |
Note the
Battery Backup side and
the
Surge Protection side |
LCD Monitor |
Models vary
- usually Dell, Acer, LG, or HP
The monitor is how you view the
information on the PC.
There are
typically only 2 connections:
-
Power
Standard thick black cable; same as
PC and other computer equipment
-
Video input
Older (and most) models use the blue
analog VGA connector. Newer models
may use the white, digital DVI or
even the newest HDMI connector (if
the PC supports it). For most of our
uses, it's the blue connector.
If there is no video on the screen,
check to ensure the power light is on on
the monitor.
Common color codes are:
-
Green or solid blue - on with source
signal
(May indicate a bad monitor)
-
Amber or flashing - on, but no
source signal.
(May indicate a loose cable or the
PC is off or in sleep mode
|
|
Dialup Modem |
Brand: US
Robotics
Model: 56K Dialup Modem
Used to connect to 3rd party for food
order transfers to IFH
There are
typically only 3 connections:
-
Power
Small din connector/cable to wall
wart power adapter
-
Phone Line
Connects to standards analog phone
jack for direct modem connectivity
-
PC Connection
Connects via 25-pin to 9-pin serial
cable (usually beige) to TACO PC.
Your fax and modem may share the same
phone line. If one is in use, the other
cannot use the line. Be sure to check
the fax and modem status when
troubleshooting connectivity. If your
modem is interfering with your fax, turn
it off using the switch on the front.
(Ensure it is on for the food ordering.) |
Click Here
for connection diagram |